Urrea TB912 Manual De Usuario página 15

To select the low speed,
high torque setting, turn
the tool off and let the
motor come to a com-
plete standstill. Slide the
dual range gear selector
forward fully so that the
letter"L" is shown.
To select the high speed,
low torque setting, turn
the tool off and let the
motor come to a com-
plete standstill. Slide the
dual range gear selector
backward fully so that
the letter "H" is shown.
NOTE: Make sure that the dual range gear se-
lector is either completely in Position "L" or
completely in Position "H".
Do not change gears when the tool is running.
If you have difficulty changing from one gear
range to the other, turn the chuck by hand un-
til the gears engage.
FORWARD/REVERSE CONTROL
The forward/reverse control determines the di-
rection of rotation of the tool.
To select forward rota-
tion, release the trigger
switch and push the for-
ward/reverse control to
the left side of the tool.
To select reverse, push
the forward/reverse con-
trol to the right side of
the tool.
The center position of the control locks the
trigger in the off position
WARNING: When changing the position of
the control, make sure the trigger is released
and the motor is stationary.
NOTE: The first time the tool is run after chang-
ing the direction of rotation, you may hear a
click on start up. This is normal and does not
indicate a problem.
TORQUE ADJUSTMENT COLLAR
Your drill is fitted with a variable clutch, which
is operated with the torque adjustment ring.
Once adjusted, the clutch will work at a pre-
E N G L I S H •
determined torque; this avoids screwing too
deeply or damaging your drill.
Torque adjustment varies with the types of
screw used and the working material. Always
start using a low torque and increase gradually
to achieve suitable operation.
Select the desired operating torque by turning
the torque adjusting ring to the appropriate
setting.
FUNCTION SELECTOR; DRILL / SCREWDRIVER
Two working modes are
available on this tool:
drilling and screw driving.
To select any of the
modes, rotate the func-
tion collar to the symbol
until it aligns with the
indicator on the housing.
This symbol " " indicates the DRILL POSI-
TION. Use this mode for high speed drilling
(wood, aluminium, and steel). The clutch will
be locked.
To work in the SCREWDRIVER mode simply se-
lect a torque number.
LED WORK LIGHT
Your drill has a LED work
light will come on when
the trigger switch is de-
pressed. The LED work
light will turn off when
the trigger switch is re-
leased.
This provides additional lighting on the surface
of the workpiece for operation in lower-light
areas.
IMPORTANT:
Follow the next indications according with this
signals.
1. If the LED light flashes every 0,2 seconds
that means that the battery pack needs to be
charged.
2. If the LED keeps flashing every second, it
means that the battery pack is overloaded or
the temperature is higher. Leave it to rest for
10 minutes before installing.
U se r's m a n ua l
15