Hands-Free Function - Hama Gentleman-M Instrucciones De Uso

4.4 Automatic Bluetooth
successful pairing)
• Make sure that your Bluetooth
device is on and Bluetooth
• Make sure that the speaker is located within the
Bluetooth
range of max. 10 metres.
®
• Switch on the speakers as described in 4.1
Switching the product on and off.
• After successful connection, the status LED (8) will
light up in blue. An acoustic signal confirms that
connection was successful.
Note – Connection impaired
• After the speaker and terminal device have been
paired, a connection is established automatically.
If the Bluetooth connection is not established
®
automatically, check the following:
• Check the Bluetooth
device to see whether Hama Gentleman-M is
connected. If not, repeat the steps listed under
Bluetooth pairing.
®
• Check whether your terminal device and the
speaker are less than 10 metres apart. If not, move
them closer together.
• Check whether obstacles are impairing the range.
If so, move the devices closer together.
4.5 Audio playback (via Bluetooth
Start and control audio playback on the connected
terminal device accordingly. Alternatively, audio
playback can also be controlled on the speaker (if the
connected device supports this function).
• Press the function button (5) to start or pause
►
audio playback.
• Briefly press the + function button (6) to skip to the
next track.
• Briefly press the – function button (4) to go back to
the previous track.
• Hold down the + function button (6) to increase the
volume.
• Hold down the – function button (4) to reduce the
volume.
4
connection (after
®
capable terminal
®
is activated.
®
settings of your terminal
®
)
®
4.6 MP3 audio playback (via microSD card media
player connection)
The speaker can also play MP3 audio files from microSD
card storage media.
• Insert a microSD card into the microSD card slot under
the cover (2). The speaker automatically switches to
media player mode.
• Press the function button (5) to start or pause
►
audio playback.
• If you want to remove the microSD card, pause
playback first; then take out the microSD card.

4.7 Hands-free function

You can use the speaker as a hands-free set for your
mobile phone. For this function, the mobile phone must
be connected to the speaker via Bluetooth
• Press the function button (7) once to answer an
incoming call.
• Press and hold the function button (7) for approx. 2
seconds to reject an incoming call.
• You can put a call on hold by pressing and holding
the function button (7) for approx. 2 seconds.
• Press and hold the function button (7) again to
continue the call.
• During a call, press the function button (7) once to
end the call.
Note – Call quality
To increase the call quality, make sure that you are
near the speaker with your mobile phone during the
call.
5. Operation – NFC connection
Note
• To be able to connect your terminal device to
the speaker using NFC, your terminal device
must be compatible with NFC technology. For
more information, please refer to the operating
instructions of your terminal device.
• Note that the presence of mobile phone cases,
covers or other materials between the speaker and
the back of your terminal device can interfere with
connection or even prevent it.
• Note that NFC has a short transmission range of
about 10 cm.
.
®