Cleaning Agents; Malfunction Table - Siemens iQ700 HF25G5L2 Instrucciones De Uso

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
sharp or abrasive cleaning agents, ■
metal or glass scrapers to clean the glass in the appliance
■
door,
metal or glass scrapers to clean the door seal,
■
any coarse scouring pads or cleaning sponges,
■
cleaning agents with high concentrations of alcohol.
■
Wash new sponge cloths thoroughly before use.
Area Cleaning agents
Appliance front Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Do not use glass clean-
ers or metal or glass scrapers for clean-
ing.
Door panels Glass cleaner:
Clean with a dish cloth. Do not use a
glass scraper.
Door seal Hot soapy water:
Do not remove. Clean with a dish cloth; do not scrub. Do
not use a metal or glass scraper for
cleaning.

Malfunction table

Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Malfunction table
Problem
The appliance does not work
The appliance is not in operation. A
cooking time appears in the display.
The microwave does not switch on.
It takes longer than before for the
food to heat up.
10
Possible cause
Faulty circuit breaker
Plug not plugged in
Power cut
Incorrect operation
The start button was not pressed after the set-
ting had been made.
The door was not fully closed.
The start button was not pressed.
The microwave power setting is too low.
A larger amount than usual has been placed
in the appliance.
The food was colder than usual.
Area Cleaning agents
Accessories Hot soapy water:
Soak and then clean with a dish cloth or
a brush.
Stainless steel Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Remove flecks of
limescale, grease, starch and albumin
(e.g. egg white) immediately. Corrosion
can form under such residues. Special
stainless steel cleaning agents can be
obtained from the after-sales service or
from specialist retailers.
Cooking compart- Hot soapy water or a vinegar solution:
ment made of stain- Clean using a dish cloth and then dry
less steel with a soft cloth.
If the oven is very dirty: use oven
cleaner, but only when cooking com-
partment is cold. It is best to use a stain-
less-steel sponge. Do not use oven
spray or other aggressive oven cleaners
or abrasive materials. Scouring pads,
rough sponges and pan cleaners are
also unsuitable. These scratch the sur-
face. Allow the interior surfaces to dry
thoroughly.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Remedy/information
Look in the fuse box to make sure that the
fuse for the appliance is OK.
Plug in the plug
Check whether the kitchen light is working.
Switch off the circuit breaker in the fuse box.
Reconnect the circuit breaker after approx.
10 seconds.
Press the start button or switch off the appli-
ance.
Check whether food remains or foreign
material is trapped in the door. Make sure
that the sealing surfaces are clean. Check
whether the door seal is twisted.
Press the start button.
Select a higher power setting.
Double the amount = almost double the time
Stir or turn the food during cooking