Slide Switch - Porter Cable PCE810 Manual De Instrucciones

the latch is closed. Do not operate the
grinder with a loose guard or the clamp
lever in open position.
5. REMOVING - To remove the guard,
open the guard latch, rotate the guard
so that the lugs on the guard are
aligned with the slots on the gear case
cover, and pull up on the guard.
B
8
C
FIGURE D
NOTE:
The guard is pre-adjusted to
the diameter of the gear case hub at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
screw (10) with latch in the closed position
and guard installed on the tool.
CAUTION:
Do not tighten the
adjusting screw with the latch in the open
position. Undetectable damage to the
guard or the mounting hub may result. If
the guard cannot be tightened by the guard
latch, do not use the tool and take the tool
and guard to a service center to repair or
replace the guard.
NOTE
:
Edge grinding and cutting can be
performed with Type 27 wheels designed
and specified for this purpose; 1/4" (6.35
mm) thick wheels are designed for surface
grinding while thinner Type 27 wheels need
to be examined for the manufacturer's
label to see if they can be used for surface
grinding or only edge grinding/cutting.
A Type 1 guard must be used for any
wheel where surface grinding is forbidden.
Cutting can also be performed by using a
Type 1 wheel and a Type 1 guard.
3
D
10
OPERATING INSTRUCTIONS
WARNING:
protection that conforms to ANSI
Z87.1(CAN/CSA Z94.3) while operating this
power tool.
WARNING:
practical way to secure and support
the work piece to a stable platform.
Holding the work by hand or against your
body leaves it unstable and may lead to
loss of control.
:
NOTE
Before cutting any type of
material, be sure it is firmly anchored or
clamped to prevent slipping.

SLIDE SWITCH

CAUTION:
(5) and body of the tool (4) firmly to maintain
control of the tool at start up and during use
and until the wheel or accessory stops
rotating. Make sure the wheel has come to a
complete stop be fore laying the tool down.
CAUTION:
full speed before touching tool to the work
surface. Lift the tool from the work
surface before turning the tool off.
• To start the grinder, push the slider
switch (1) forward. Release the slider
switch to turn the grinder off.
• For continuous operation, slide and
depress the switch forward until it
locates the lock ON position.
• To turn the tool off, press the rear of the
slider switch. A spring action returns
the switch to the OFF position.
SPINDLE LOCK
WARNING:
operation, turn off and unplug tool
before performing the following
operations. Failure to do this could result
in serious personal injury.
The spindle lock button (6) is provided
to prevent the spindle from rotating when
installing or removing wheels. Operate the
spindle lock only when the tool is turned
off, unplugged, and the wheel has come
to a complete stop.
8
Always use proper eye
Use clamps or another
Hold the auxiliary handle
Allow the tool to reach
To prevent accidental