Initial Operation; Function Switch; Overheating Protection - Clatronic HL 2770 Instrucciones De Servicio

5....-05-HL 2770
GB
1. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
2. Make sure that the degree of protection of the socket to which the device is
connected is of at least 10 ampere!
3. Place the device on any heat-resistant flat surface. Ensure that air can enter
and leave unhindered. The distance from the air inlet and outlet grill to the
nearest wall should be at least 20 centimetres.
4. The indicator light lights up when the unit is in operation.
5. After use, pull the plug out of the socket.
O = OFF
1 = Hot air (1000 W)
• You can set the room temperature with the temperature control.
LO = Lowest level
• Turn the thermostat control knob to the highest level. The LED will light up.
• Once the desired room temperature is reached, turn the thermostat control
knob slowly back until the device shuts off. The thermostat maintains the set
room temperature by switching the device on and off.
Cold air operation:
If you would like to use the machine as a ventilator, move the function switch to
and turn the temperature regulator to the HI position.
The device is equipped with an overheating protection that switches the device
automatically off in case of overheating. Shift the function switch to „0" position and
pull out plug out of the socket. Let the device cool down for about 10 minutes before
using it again.
Should the overheating protection shut the device off again shortly after, there is
probably a defect. Switch off the device again and pull out the plug. Let the device
be checked by an authorized dealer or by our customer service (or contact your
dealer).
24
29.04.2003 15:40 Uhr

Initial Operation

Function Switch

2
Thermostat
HI

Overheating Protection

Seite 24
= Cold air
= Hot air (2000 W)
= Highest level