5....-05-RA2801_03
•
Special care must be taken when the radiator is used in the vicinity of children
or when left unattended.
•
Do not insert any objects into the radiator.
•
Ensure that a safety distance is maintained between the power cord and the
housing.
•
In order to avoid overheating it is important that the air inlets and outlets are
kept clear. Never suspend objects in front of or above the radiator.
•
Do not use the radiator in the open air.
•
This radiator is not suitable for use in bathrooms, washing rooms or rooms
which are used in a similar manner. The radiator must never be placed in a
position where it could fall into a bathtub or other water container.
•
Do not cover the radiator.
•
The radiator should not be placed directly below a mains power socket.
•
The radiator should only be used in an upright position.
•
If the radiator should fall over, first remove the plug from the socket and allow
the radiator to cool down before returning it to an upright position.
•
Before the radiator is used, the rollers must be attached.
•
To do so, place the radiator upside-down (hold the underside facing upwards);
avoid hard surfaces. Attach the castors between the first and second, and bet-
ween the second-before-last and the last fin in the correct position.
•
Pass the U-shaped clamps through the holes of each roller carrier and then
tighten the wing nuts.
Only connect the machine to a properly installed safety socket, 230 V/50 Hz. The
POWER indicator light signals that the device is ready for operation.
The heating power is determined by the various levels. The radiator offers 3 heating
levels for ideal comfort: Bring the operational switch I or II down. The indicator light
of the switch is lit.
Operational switch I alone is on:
Operational switch II alone is on:
Operational switches I + II are on:
Operational switch set to 0:
05.06.2003 10:53 Uhr
Assembling the Rollers
Initial Operation
Levels/Heating Power
= low power
= medium power
= high power
Radiator is off.
Seite 23
23
GB