Assembly - Husqvarna H342SL Manual Del Dueño

1
BAGGER SUPPORT ASSEMBLY
(See Fig. 1)
1. Remove and discard the upper bolt on both sides of
the drawbar. Using the same holes, install the shoulder
bolts supplied and tighten securely.
2. Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
3. Be sure support assembly is seated properly and secure
with retainer spring supplied.
REMOVE AND DISCARD
UPPER BOLTS AND INSTALL
SHOULDER BOLTS SUPPLIED
SUPPORT

ASSEMBLY

RETAINER
SPRING
ASSEMBLY
3064
PIN
DRAWBAR
Fig. 1
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain
the assistance of another person for mounting cover as-
sembly to tractor.
1. Position cover assembly on ground behind tractor.
2. Lift and rotate cover to align cover brackets with support
assembly tubes.
3. Slide cover assembly down onto the support tubes.
COVER
ASSEMBLY
03024
5
SUPPORT
ASSEMBLY
Fig. 2