Removing The System; Basic Functions; Volume Adjustment; Multi-Language Voice Messages - Nolan N-com x Serie Manual Del Usario

5

REMOVING THE SYSTEM

To remove the system from the helmet, proceed as for the installation, by removing the various parts.
Important: to remove the keypad, proceed as follows.
•
Remove the keypad from the helmet shell (Fig. 48).
•
Remove the Flex of the keypad from the connector found on the e-box (Fig. 49).
•
Now completely remove the keypad from the helmet.
Fig. 48
The keypad can be removed in case you decide to no longer use the system. However, it cannot be reused
again as it will have lost its adhesive properties. Contact your local dealer to purchase a new keypad double
sided-adhesive tape that will stick properly to the helmet shell.
6

BASIC FUNCTIONS

Note: Before using the N-Com device for the first time, recharge the battery completely for at least 10 hours.
To obtain best performances from the battery, it is recommended to completely recharge the battery the first
few times. Afterwards, you can recharge the battery for shorter periods. Whenever possible, it is best to
recharge the battery completely.
System ON
System OFF
6.1

Volume adjustment

You can easily adjust the volume by tapping the "" or the "" key. You will hear a beep when the volume
reaches the maximum or minimum level.
The volume is independent for each sound source. Once it is set for a specific source (phone call, radio, Mp3),
it will be remain in memory even after the system is switched off.
However, if you adjust the volume during stand-by mode, it will affect volume levels of every audio source.
6.2

Multi-language voice messages

The N-Com system features voice messages that provide information on the system and on the active
functions.
The language set by default is English. The language of the voice messages may be changed through the
specific firmware installable with the N-Com EASYSET program. Please refer to the online HELP for instructions
on how to change the language settings.
Available languages: Italian, English, French, German, Spanish, Dutch.
The default function is enabled on the device.
You can enable / disable the "VOICE ANNOUNCEMENTS" function by using the N-Com EASYSET
program.
Fig. 49
Press "n" and keep it pressed for about 2 seconds, until the LEDs turn on and
you hear the voice announcement.
Press "n" and keep it pressed for about 6 seconds, until the LEDs turn off and
you hear the voice announcement.
15