Safety Notices - Tannoy CVS Serie Guia De Inicio Rapido

8 CVS (EN 54) Series
11.
其他的重要信息
¼'' TS
13.
14.
15.
1.
2.
3.
4.
5.
6.
7. 8.
9.
10.
法律声明
12.
Midas, Klark Teknik, Lab Gruppen,
Lake, Tannoy, Turbosound, TC Electronic, TC Helicon,
Behringer, Bugera Coolaudio Music Tribe
Global Brands Ltd.
© Music Tribe Global Brands Ltd. 2018
保修条款
musictribe.com/warranty
16.
17.
2000
1. Introduction
Thank you for purchasing this Tannoy Ceiling loudspeaker. This product range is suited for high-level music and speech reinforcement applications requiring
Music Tribe
exceptional sonic quality with uncompromised reliability.
2. Unpacking
Every Tannoy product and accessory is carefully inspected before packing. After unpacking, please inspect your product to make sure no damage has occurred in
transit. In the unlikely event of any damage, would you please notify your dealer immediately and retain your shipping carton, as your dealer may ask you to return the
faulty unit to them for inspection.
Each CVS (EN54) loudspeaker is packed in pairs and provided with the following accessories as standard; C-Ring, tile-bridge kit, cut-out template, and paint mask.
A plaster (mud) ring is also available as an optional extra.

3. Safety Notices

Some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to provide security of a backup support. A secondary
support line should be attached from the safety loop on the rear of the product to a source point on the ceiling. Please consult the relevant construction codes in
your region.
When using a power driver to install the product it is essential to use the correct torque level settings to avoid over tightening and damage to the ceiling material
or clamps.
Recommended torque setting: 1.5 Nm.
Tannoy will not be held responsible for any damages caused by the improper installation of these loudspeakers.
SAFETY NOTE:
In order to comply with the relevant fi re safety regulations (ie. BS 5839: 1998), it is required that in the event of fi re, that failure of the circuit to which the loudspeaker is connected does not occur before evacuation of the building is complete. Suitable measures include: - a) use
of terminal blocks (for connection to primary) with a melting point of not less than 650°C, for example constructed from ceramic materials; b) use of terminal blocks of a lower melting point but protected with thermal insulation; c) use of terminal blocks such that, on melting,
an open-circuit or a short-circuit does not occur.
Quick Start Guide 9