Safety Instructions For Maintenance; Assembly - McCulloch M46-160AWRPX Manual De Usuario

• Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use soap and water to
remove the fuel.
• Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
• Be careful with fuel. Fuel is flammable and the fumes
are explosive and can cause injuries or death.
•
Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is a sufficient airflow.
• Do not smoke near the fuel or the engine.
• Do not put warm objects near the fuel or the engine.
• Do not add the fuel when the engine is on.
WARNING: Read the warning instructions
that follow before you use the product.
• The exhaust fumes from the engine contain carbon
monoxide, an odourless, poisonous and very
dangerous gas. Do not start the engine indoors or in
closed spaces.
• Before you do the maintenance on the product, stop
the engine and remove the ignition cable from the
spark plug.
• Use protective gloves when you do maintenance on
the cutting equipment. The blade is very sharp and
cuts can easily occur.
To assemble the handle
1. Align the screw holes at the bottom of the handle
with the screw holes in the handle assembly.
2. Attach the screws, washers and knobs.(Fig. 16 )
3. Tighten the knobs fully.
4. Use the straps to attach the cables to the handle.
(Fig. 17 )
Note: Make sure that the tension in the cables is not
too high.
5. To set the handle height, loosen the lower knobs,
adjust the handle height and tighten the knobs fully.
(Fig. 18 )
To install the starter rope
1. Attach the loop for the starter rope and the T-knob,
but do not tighten fully.(Fig. 19 )
2. Hold the engine brake handle against the handlebar.
350 - 004 - 17.10.2017

Safety instructions for maintenance

Assembly

• Make sure that the engine is cool before you refuel.
• Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
• Do not add fuel to the engine in an indoor area. Not
sufficient airflow can cause injury or death because
of asphyxiation or carbon monoxide.
• Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
•
Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
• Do not put too much fuel in the fuel tank.
• Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
injury or death. Do not change the product. Always
use accessories that are approved by the
manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this owner's
manual. All other servicing must be done by an
approved McCulloch service agent.
• Let an approved McCulloch service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
3. Slowly pull out the starter rope and put it into the
loop for the starter rope.(Fig. 20 )
4. Tighten the T-knob.(Fig. 21 )
To assemble the grass catcher
1. Attach the clips of the top part of the grass catcher to
the holes on the lower part of the grass catcher.(Fig.
22 )
2. Lift the rear cover.
3. Attach the hooks on the grass catcher to the top
edge of the chassis.(Fig. 23 )
4. Put the lower part of the grass catcher into the grass
discharge channel.
To assemble the mulch plug
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the discharge channel.(Fig.
24 )
9