Tripp-Lite SmartOnline Manual Del Propietário página 6

2. Installation
2.4 Optional Connections
EPO Port Connection
2
This optional feature is only for those applications
that require connection to a facility's Emergency
Power Off (EPO) circuit. When the UPS is
connected to this circuit, it enables emergency
shutdown of the UPS's inverter and inhibits
transfer to internal bypass. Using the cable
provided, connect the EPO port of your UPS (see
2a
) to a user-supplied normally closed or
normally open switch according to the circuit
2b
diagram (see ).
Note:
1. If using a cable other than what is supplied,
the cable should not have a resistance of
greater than 5 ohms.
2. If a non-latching EPO switch is used, the
EPO must be held for a minimum of 1
second. This does not apply to a latching
EPO switch.
CAUTION: The EPO port is not a phone line
surge suppressor; do not connect a phone line
to this port.
UPS Unit State when asserting EPO with AC line present:
LEDs Output
OFF OFF
To restart the UPS unit after asserting EPO with AC line present:
1. Verify that the EPO assertion has been removed or cleared.
2. Remove AC line power to the UPS unit.
3. Reapply AC line power. Now the UPS will start back up in Standby mode.
UPS Unit State when asserting EPO without AC line power:
LEDs Output
OFF OFF
To restart the UPS unit after asserting EPO without AC line power:
1. Verify that the EPO assertion has been removed or cleared.
2. Reapply AC line power to the UPS unit. Now the UPS will start back up in Standby mode.
201102140 932835.indb 6
( continued )
( continued )
Fans Serial
ON ON
Fans Serial
OFF OFF
6
2a
Some models may differ.
2b
SNMP
ON
SNMP
OFF
4-5
USB
ON
USB
OFF
3/29/2011 4:50:15 PM