Changing Components - Skymsen DB-6 Manual De Instrucciones

Table - 02
Problem Cause
* The machine does not * Electric energy shortage
start.
* Problem with the internal
or external wiring.
* Problem with the internal
* Burnt smell or smoke
or external wiring.
* Belts sliding
* The machine starts, but
w h e n t h e p r o d u c t i s
placedon the Disc, the disc
stops or turns slowly.
* Problems with the
Electric Motor
* Abnormal noises. * The abrasive disc is not
correctly placed.
* Problems with the
bearings
* Water leaks through the * The retainer is damaged
botton.
5.2 Adjustments and Replacement of Components
The Abrasive disc is covered with a Aluminum Oxide coat
responsible to wear the aliments peel . After some time of use the Aluminum
Oxide wears itself out, and therefore the efficiency of the machine is reduced
.
Go to the nearest Technical Assistant bringing the worn Disc to
receive a new Aluminum Oxide coating .
Solution
* Check Electric energy source.
* Call Technical Assistance.
* Call Technical Assistance.
* Call Technical Assistance.
* Call Technical Assistance.
* Place correcly the Abrasive Disc.
* Call Technical Assistance.
.
* Call Technical Assistance.
11
5.3 Diagrama Eléctrico
6. CONSEJOS GENERALES
- Do not wear loose fitting clothes while operating the unit. Do not use bracelets or any other piece of jewelry. Have
your hair always shortened and held up (use hair fishnets if necessary) in a way it cannot reach any part of the machine.
Roll up any loose sleeves.
- SKYMSEN is not responsible for any harm or injury caused by the negligent or inappropriate use of this equipment by
any operator. This equipment must be operated only by persons whose age equals or exceeds 18 years old, in a safe and
sound state of mind, free from the influence of any kind of drugs and alcohol, that received proper training and
instructions regarding the correct operation of this machine, that are wearing correct and authorized safety clothes. All
,
and any kind of modifications carried on and applied to this machine immediately nullifies any kind of warranty and
may result in harm and injuries to the individuals operating this machine and to individuals that are located in the
machine surrounding areas while it is being operated.
- Under no circunstances place your hands in the moving parts of the machine while it is being used. Make sure the
machine has come to a complete stop before acessing the processed ingredients.
24