Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Range Hood Use
Reset the filter alarm
•
Press the POWER button for 3 seconds to reset the filter alarm.
NOTE
Every 50 hours of fan use, The filter alarm light (low button) will blink,
indicating The filters may need to be cleaned.
Performance (CFM) Conversion
•
Press and hold the HIGH and BOOST button on the hood for 3
seconds to convert Blower performance.
•
Normal mode:
appears in the display. The blower will operate
normally (Max 390 CFM).
•
Power mode:
appears in the display. The blower will operate
powerfully (Max 600 CFM).
Range Hood Care
IMPORTANT: Clean the hood and baffle filters frequently according to the
following instructions. Replace the baffle filters before operating the hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or soap-
filled scouring pads to clean the hood.
Always wipe dry to avoid water marks.
Cleaning Method:
•
Liquid detergent soap and water or all-purpose cleanser
•
Wipe with a damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
•
Do not use cleaning agents containing bleach.
Stainless Steel Baffle Filter:
1. Remove the filter by pulling the spring release handle, and
then pulling down the filter.
A. Spring release handle
CAUTION
•
Do not activate this function without qualified person.
We recommend that a qualified technician install the range hood.
It is the installer's responsibility to ensure the range hood complies
with the installation clearances specified for the product.
To activate Power mode of this function, the Make-up air system is
required.
Makeup Air
•
When using ventilation systems with greater than specified CFM of
air movement, review local building codes as they may require
makeup air systems. Consult a HVAC professional for specific
requirements for you're area as CFM requirements can vary between
locales.
•
Consult a HVAC professional to select the correct CFM capacity
range hood for your application. The CFM capacity depends on the
range or cooktop BTU rating, size and location, size of the kitchen
and the range hood ductwork in the kitchen.
2. Wash the stainless steel baffle filter as needed in your dishwasher
or a hot detergent solution.
3. To reinstall the filter, first make sure the spring release handles are
toward the front. Insert the stainless steel filter into the
upper track.
4. Push in the spring release handle.
5. Push up on the stainless steel filter, and then release the handle to
latch the filter into place.
WARNING
When removing the filter, please hold it with both hands to make sure it
does not fall.
Replacing an LED Lamp
The LED lights are replaceable by a service technician only. See the
support contact information in the Warranty section.
Replacing the charcoal filter
After approximately one year of use, the charcoal filter should be re-
placed with a new one, as the odour reduction capacity will be reduced.
NOTE
Charcoal filters are not included with the hood. They must be ordered
from your supplier or Samsung service center.
Order the needed kit specifying your hood model and width size.
A
English
11
Capítulos
Tabla de contenido
