Fitting The Header Assembly - NAMCO TIME CRISIS 2 Dlxe Manual Del Operador

Tabla de contenido

5-2 Fitting the Header Assembly

The Header Assembly has a forward centre of gravity, so it is important that at
least two people are used to fit or remove the Header Assembly.
The fitting position of the Header Assembly is very high, and it is important
that a means of reaching the height safely, without stretching, is available.
(e.g. steps, step stool etc.)
1.
Remove 2off tork screws (M5x15) and remove the connector cover.
2.
Place the header on to the monitor cabinets and slide it backwards so that
it engages under the fixing brackets at the back.
3.
Connect the connector, and refit the connector cover using the 2off tork
screws (M5x15).
4.
Retain the header in position with supplied 4off hex head screws (M6x30),
flat and spring washers, and supplied washers C.
Page 39
Tabla de contenido
loading

Tabla de contenido