Joining The Monitor (L) And (R) Assemblies - NAMCO TIME CRISIS 2 Dlxe Manual Del Operador

5-1 Joining the Monitor (L) and (R) Assemblies

1. Place the monitor (L) and (R) assemblies together in their final location
and lower the eight, (4 on each monitor), level adjusters until the castors
are raised approx 5mm from the ground.
NOTE:- When adjusting the level adjusters, ensure that the top and front faces of
the monitor assemblies are level with each other.
Poor adjustment will prevent the fitting of the Joint Assy and Header Assy.
Note: If the location site of this machine has a polished floor it is recommended
that rubber pads are fitted under the level adjusters to prevent the
machine sliding on the floor when in use.
Page 36