How To Assemble Your Ceiling Fan; How To Assemble Your Ceiling Fan Blades - Fanimation LEVEL LP8347B Serie Manual De Instrucciones

1. Mount your fan by sliding the motor assembly over
the mounting bracket with the two loosened screws
going into the "L" slots in the ceiling bracket. Be sure
all wiring is tucked into the motor housing and is not
pinched. Once the motor assembly is flush with your
ceiling, turn clockwise to seat the screws into the keyed
portion of the slot. Tighten the screws. (Figure 1)
2. Assemble the motor assembly to ceiling bracket
using the previously removed screws and securely
tighten all screws. (Figure 2)
3. Please remove the flexible bushing prior to pushing
the canopy trim ring up.
conceal the screws, such that the mounting tabs seat
into the dimpled grooves in the ceiling bracket midway
between the screws. (Figure 3)
How to Assemble the Ceiling Fan Blades
1. Slide blades through slots in motor housing and
attach to the motor hub using the #8-32 washer head
screws and fiber washers. Make sure the screws
securing the blades to the motor hub are tight and are
Figure 1)
properly seated. (
NOTE:
Periodically check blade hardware and
resecure if necessary.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.

How to Assemble Your Ceiling Fan

Push the canopy trim ring up to
Motor
Assembly
HARDWARE USED:
#8-32
WASHER HEAD
SCREWS
FIBER WASHER
8
" L " Slot
Screw
Figure 1
Figure 2
Figure 3
Blade
#8-32
Washer Head Screws
and Fiber Washer
(3 each per blade)
Figure 1
x 9
x 9