Mains Operation; Operation On Non-Rechargeable Batteries - Philips AVENT SCD535 Manual Del Usuario

Mains operation

1 Put the large appliance plug in the baby unit and put the adapter in a wall socket (Fig. 2).

operation on non-rechargeable batteries

The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Place batteries in the baby unit if you do not want to use it from the mains or if you want to be
sure of backup power in case of mains failure. Replace the batteries when the baby unit indicates
that the batteries are low (the empty battery symbol flashes on the display and the text 'Battery
low' appears).
Unplug the baby unit and make sure your hands and the unit are dry when you insert the
non-rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries (Fig. 3).
2 Insert four non-rechargeable batteries (Fig. 4).
Note: Make sure the + and - poles point in the right direction.
3 Reattach the lid (Fig. 5).
parent unit
operation on rechargeable battery pack
The parent unit comes with a rechargeable Li-ion 1000mAh battery pack.
Charge the parent unit before you use it for the first time or when the parent unit indicates that the
battery is low (the empty battery symbol flashes on the display and the parent unit beeps). The
parent unit starts indicating that the battery pack is low 30 minutes before the battery pack is
completely empty.
Note: If the rechargeable battery pack is completely empty, the parent unit automatically switches off
and loses contact with the baby unit.
1 Remove the lid of the compartment for the rechargeable battery pack (Fig. 6).
2 Insert the rechargeable battery pack (Fig. 7).
3 Reattach the lid (Fig. 8).
4 Insert the small appliance plug into the charger, put the adapter in a wall socket and place the
parent unit in the charger (Fig. 9).
The charging light on the charger goes on.
,
The display shows a charging battery symbol to indicate that the parent unit is charging.
,
5 Leave the parent unit in the charger until the battery pack is fully charged.
During charging, the charging light on the charger lights up continuously.
,
When the battery pack is fully charged, the display of the parent unit shows a full battery
,
symbol T.
- When you charge the parent unit for the first time or after a long period of disuse, switch it
off and let it charge continuously for at least 10 hours.
- Charging normally takes 4 hours, but it takes longer when the parent unit is switched on while
charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
- When the battery pack is fully charged, the parent unit can be used cordlessly for up to 24
hours.
EngliSh
9