Operation - ProTeam GoFree Flex Pro Battery 107513 Manual Del Propietário

This charger is intended to recharge ProTeam Lithium Ion battery 107513.
WARNING
CHARGING PROTEAM LITHIUM ION BATTERY PACKS
Lithium Ion batteries deliver fade-free power for their entire run time. The GoFree Flex Pro
vacuum will not gradually lose power due to decreasing battery charge. The vacuum will
perform at its normal performance level until the battery has been depleted. Once this hap-
pens, recharging of the battery is required. It is not necessary to drain the battery pack com-
pletely before recharging.
If none of the charger LEDs is lit at any point during the charging process, remove the bat-
tery pack from the charger to avoid damaging the product. DO NOT insert another battery.
Contact ProTeam Customer Service with any issues.
BATTERY PROTECTION FEATURES
ProTeam 36-volt Lithium Ion batteries are designed with features that protect the Lithium Ion
cells and maximize battery life. When the battery has reached its minimum voltage level the
electronics will shut off the battery. Once the battery shuts off, it must be recharged.
PREPARING BATTERY PACK FOR
CHARGING
1. Plug the charger's power cord into
the charger (Figure A).
2. Install battery on charger as shown
(Figure B) and lock in position by
turning knob clockwise.
3. Plug the charger's power cord into
120V (230 V for Europe) wall outlet
(Figure C).
4. The left indicator light should turn
Red. The right indicator light will
flash Green when charging and will
stop flashing and remain Green when
fully charged (Figure D). The battery
pack may require approximately 2.5-
3 hours to fully charge for the 12Ah
battery.
Note: Prior to charging, the battery may
be in standby mode for approximately
an additional hour to allow cooling.
5. Verify the charge level of the battery
pack by pressing the power level
indicator button on the front of
the pack. (Figure E). Five Red lights
indicate a fully charged battery.
Remove battery from charger and
unplug cord from wall outlet after
charging.
4
O P E R A T I O N
I N T R O D U C T I O N
Charge in a well-ventilated area. DO NOT block charger
vents. Keep them clear to allow proper ventilation.
Figure A
Figure C
Figure E
*Battery pack may get warm while charging.
ProTeam Owner's Manual
Figure B
Figure D