Cleaning The Appliance; Burnt-On Dirt; Discoloration Of The Burners - Gaggenau VG425211CA Manual De Instrucciones

Encimera a gas
Ocultar thumbs Ver también para VG425211CA:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Cleaning the appliance

Clean the appliance after each use once it has cooled
down. Remove liquids that have boiled over or spilled
immediately and do not allow any food remnants to burn
on.
Make sure that the ventilation openings under the pan
support are always clean. The ventilation openings may
not be covered.
Dry the burners thoroughly after cleaning. Only operate
the appliance when the burners are dry. Damp burners
can cause ignition problems and/or an unstable flame.
During assembly, make sure that the burner parts (lugs)
are in the correct position. All parts must be positioned
straight.
Appliance part/
Recommended cleaning
Surface
Stainless steel
Use soapy water and dry with a soft
surfaces
cloth. Only use a minimal amount of
water when cleaning so that no water
enters the appliance.
Soak burnt-on remnants with a small
amount of soapy water; do not scour.
Remove heavy soiling or yellow dis-
coloration caused by heat using our
stainless-steel cleaning agent (arti-
cle no. 00311499).
Pan support
Carefully remove for cleaning. Soak
in the sink. Clean using a scrubbing
brush and detergent.
Clean the area around the rubber buf-
fers carefully so that they do not
become detached.
Rinse with clean water before leaving
to dry.
Do not clean in the dishwasher.
Burner parts
Use soapy water and dry with a soft
cloth. Make sure that the openings
are not blocked.
Take care that no small parts are lost.
Do not clean in the dishwasher.
Control knob
The soapy cloth may not be too wet.
Dry with a soft cloth.
Cleaning and maintenance

Burnt-on dirt

For hard-to-remove, burnt-on dirt, you can order a
cleaning gel from our online shop, from your specialist
retailer or our Customer Service (item
number 00311859). It is suitable for pan supports and
the stainless steel recess. If necessary, let the dirt soak
overnight. Heed the instructions on the cleaning agent.
NOTICE
DAMAGE TO THE SURFACE -
Do not use the cleaning gel on the burner parts.

Discoloration of the burners

After long use, the burner parts made of brass become
darker due to natural oxidation. The change in the color
does not affect use user benefits.
en-us
17
Tabla de contenido
loading

Tabla de contenido