Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Strap Shortening Instructions
Your wristwatch strap may be shortened in two ways.
1. At the buckle
Unlock the safety cover (if applicable) and open the
buckle. The strap is held in position by a spring bar.
The spring bar can be compressed with a pointed
tool to enable shortening of the strap. Move the
strap to the desired position and allow the spring bar
to lock into place.
2. At the strap
Shortening of the strap can also be achieved by
removing segments. Open the buckle and remove
the spring bar as described in part 1.
Place the wristwatch on a soft surface with the dial
facing downward. The segments that can be
removed are marked with an arrow. Push a pointed
tool into the opening on the backside of the strap
and push the bolt out of the strap in the direction of
the arrow. Pull out the bolt (you may need to use
tweezers).
The strap can now be disassembled.
Remove as many segments as necessary in the
described fashion and reassemble the strap by
pushing the bolt inwards in the opposite direction of
the arrow. Reassemble the buckle with the spring
bar.
Replacement of battery
(SR626SW)
Battery replacements must be performed by an
expert to avoid damaging the case or gaskets.
Water resistance
Water resistant up to 3 bar. The bar value specifies
the atmospheric overpressure which is applied
during testing (DIN 8310).
Disposal of the watch
This wristwatch may not be disposed of with
normal household waste. Dispose of the
wristwatch at an approved disposal facility
or at your local recycling centre. Please observe the
current rules and regulations when disposing of the
watch. Contact the disposal system if in doubt.
- 20 -
Capítulos
Tabla de contenido
