Using Your Baby Monitor - Philips SCD465 Instrucciones De Manejo

Getting your baby monitor ready
EN

Using your baby monitor

8
> When the POWER light (B-7) flashes red, battery power is
low. Place the parent unit in the charging base (B-3) to
recharge the batteries.
The parent unit is now ready for use!
1 Position both units in the same room to test the connection.
Make sure the baby unit is at least 1 meter / 3 feet away from
the parent unit.
2 Press the ON/OFF button (A-1) to switch on the baby unit.
> The POWER Light (A-5) lights up green.
3 Switch on the parent unit using the ON/OFF switch (B-9) and
adjust the volume to the level you prefer using the VOLUME
control (B-9).
> The POWER light (B-7) lights up green.
> When connection has been established between the units,
the LINK light (B-5) on the parent unit lights up green.
4 Position the baby unit at least 1 meter / 3 feet away from
your baby.
5 Position the parent unit at the desired place within the
operating range of the baby unit but at least 1 meter / 3 feet
away from the baby unit. For more information on the
operating range see 'Technical specifications'.
Your can now monitor you baby!