Skil PWRCORE 12 ID574401 Manual Del Propietário página 14

The speed mode will be stored and applied in the next operation when the tool is turned on
again or when the direction of rotation has been changed. Reset the speed modes as desired.
NOTICE: To prevent gear damage, always allow the impact driver to come to a complete stop
before changing between high speed and low speed. The speed mode can only be changed
when the mode-indicator light is on and the trigger switch is not depressed. The mode
selector cannot be activated when the motor is running. The mode-indicator light will turn off
automatically in about one minute after operation ceases.
Removable Belt Clip (Fig. 7)
Your tool is equipped with removable belt clip,
which can be positioned on the left side of the
tool for convenient transport.
Install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib of the belt clip with the threaded
hole on the base of the tool.
c. Insert the screw and securely tighten the
screw with a screwdriver.
Remove the belt clip from the tool:
d. Remove the battery pack from the tool.
e. Use a screwdriver to loosen the screw that
attaches the belt clip to the impact driver.
f. Remove the screw and the belt clip.
Install and Remove Bits
Your tool is equipped with a quick -change
collet, making bit installation and removal very
easy.
Lock the trigger switch "OFF" by placing the
direction-of-rotation selector in the center posi-
tion.
a. To install the bit:
Push the black sleeve forward, insert the bit
into the collet, and then release the black
sleeve. Check to make sure that the bit is
firmly in place.
b. To remove the bit:
Push the black sleeve forward, pull the bit
from the collet, and then release the black
sleeve. (Fig.8)
WARNING
14
Use protective gloves when removing the bit from the tool, or first
allow the bit to cool down. The bit may be hot after prolonged use.
Fig. 7
Fig. 8
Belt Clip
Sleeve