Operating Instructions; Cleaning The Air Filter; Engine Management - Stihl HS 46 Manual De Instrucciones

English

Operating Instructions

During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
18

Cleaning the Air Filter

If there is a noticeable loss of engine
power
2
1
Loosen the captive screw (1) and
N
remove the filter cover (2).
Clean away loose dirt from around
N
the filter.
Remove the filter element (3).
N
Fit a new filter element. As a
N
temporary measure you can knock it
out on the palm of your hand or blow
it out with compressed air. Do not
wash.
Replace any damaged parts.
N
Fit the filter element (3).
N
Fit the filter cover (2) and screw it
N
down firmly.

Engine Management

Exhaust emissions are controlled by the
design of the engine and components
(e.g. carburation, ignition, timing and
valve or port timing).
HS 46, HS 46 C, HS 56 C