Storing The Machine - Stihl HS 46 Manual De Instrucciones

English
hex key to distribute the grease
evenly – avoid contact with the
cutting blades.
NOTICE
Do not completely fill the gearbox with
grease.
2
Fit the retaining plate (2) so that it is
N
flush with the gearbox housing.
Fit the gearbox cover (3), insert the
N
screws (1) and tighten them down
firmly.
HS 56
Use STIHL gear lubricant for hedge
trimmers (special accessory) to lubricate
the blade drive gear.
22
2
Unscrew the filler plug (1). If no
N
grease can be seen on the inside of
1
1
the filler plug, screw the tube (2) of
STIHL gear lubricant (special
3
1
accessory) into the filler hole.
1
Squeeze up to 5 g (1/5 oz) grease
N
into the gearbox.
NOTICE
Do not completely fill the gearbox with
grease.
Unscrew the tube of grease from the
N
filler hole.
Refit the filler plug and tighten it
N
down firmly.
1

Storing the Machine

For periods of 3 months or longer
Clean the cutting blades, check
N
condition and spray them with
STIHL resin solvent.
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Fit the blade scabbard.
N
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
Store the machine in a dry and safe
N
location (use the ring integrated in
the rear handle) – out of the reach of
children and other unauthorized
persons.
HS 46, HS 46 C, HS 56 C