Makita DUM168 Manual De Instrucciones página 15

remains inside gear housing.
2
3
012562
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
012563
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1
012564
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the
base plate of the shear blades is set in place.
1
012565
Tighten two screws with a coin firmly.
1. Base plate
1
2. Oval holes that
are overlapped
3. Hole in the base
plate of shear
blades
1. Blade cover
1
1. Bent part of the
base plate of
shear blades
1. Screws
1
2
012554
Place the undercover so that the symbol
is aligned with the symbol
012556
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
1
2
012544
At this time, make sure that the locking lever fits in the
groove in the undercover.
CAUTION:
Never use the tool without installing the undercover
•
on it.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades do not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
15
1. Locking lever
2. Undercover
on the undercover
on the locking lever.
1. Groove in the
undercover
2. Locking lever
on