Installing Or Removing Grass Shear Blades - Makita DUM168 Manual De Instrucciones

1
012526
012525
Slide the blade cover from the tool's side until the shear
blade completely hides itself and then push in it lightly
towards the tool from the front.
To remove the blade cover, take the above installation
procedure in reverse.
Installing or removing base frame
CAUTION:
Before installing or removing base frame, be sure
•
to install the blade cover.
When installing or removing base frame, take care
•
that your fingers are not be pinched between the
tool and base frame.
1
012528
To remove the base frame, upset the tool and take it out
of the groove grabbing its bottom.
1
2
3
012529
1. Shear blades
2. Blade cover
3. Blade frame
3
2
1. Groove
2
2. Base frame
1. Change lever
2. Protrusion on
base frame
3. Base frame
To install the base frame, fit the protrusion of base frame
near the change lever into the hole for the sheared grass
height setting. With the base frame so fitted, pull the
lower part of base frame and fit the other part of the base
frame in the groove in the tool.

Installing or removing grass shear blades

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing shear blades. Failure to switch off and
remove the battery cartridge from the tool may
result in serious injury from accidental start-up.
When replacing the shear blade, always wear
•
gloves without removing blade cover so that hands
and face does not directly contact the blade.
Failure to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
1
012533
Remove the base frame and place the tool upside down.
CAUTION:
Before placing the tool upside down, be sure to
•
remove the base frame.
1
4
012535
To remove the shear blade, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
10
1. Blade cover
1. Locking lever
3
2. Undercover
3. Press
4. Turn
2
on the undercover
on the locking lever.