Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1=800-222-3136.
Attach Handleand Accessory Tray
1.
Place handle (A) onto handle supports connected to
main unit. Make sure holes in handle align with holes on
handle supports.
UNPACK THEPRESSURE WASHER
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
*
Main Unit
*
Handle
*
Accessory Tray
*
High Pressure Hose
*
Spray Gun
*
Nozzle Extensionwith Quick Connect Fitting
*
Oil Bottle
*
Parts Bag (which includes the following):
*
Operator's Manual
*
Owner's Registration Card
*
Rubber Straps (2)
*
Bag containing 3 multi-colored Spray Tips
*
HandleFasteningHardwareKit (which includes):
*
Carriage Bolts (2)
*
Plastic Knobs (2)
*
Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle and accessory tray.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect pressure hose to spray gun and pump.
6.
Connect water supply to pump.
7.
Attach nozzle extension to spray gun.
2.
insert handle carriage bolts (8) through holes from
inside of unit and attach a plastic knob (C) from outside
of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle section of
the attachment bolt, the upper handle can fold forward to
store fiat atop the cold engine. DONOTfold the handle down
while the engine is hot.
3.
insert rubber straps (D) through slots (E) in back of
accessorytray and pull tight from front.
4.
Placeaccessory tray (F) over holes (G) on handle
(viewing from front of unit). Push the tree clips (H) into
the holes until they sit fiat against the accessory tray.
5.
insert multi-colored quick connect spray tips and other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.
8.
Select!attach quick connect spray tip to nozzle extension.
Tabla de contenido
