Unpack Thepressure Washer; Attach Handleand Accessory Tray; Carton Contents - Craftsman 580.752520 Instrucciones De Uso

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1=800-222-3136.
UNPACK THEPRESSURE WASHER
1. Removeeverything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Attach quick connect selector nozzle to nozzle extension.
Attach Handleand Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with holes
(C) on handle supports.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Accessory Tray
• High Pressure Hose
• Spray Gun
• Nozzle Extensionwith Quick Connect Fitting
• Quick Connect Selector Nozzle
• Oil Bottle
• Hose Wrap
• DetergentSiphoning Hose/Filter
• Bottle Bracket Wireform
• PerfectMix
TM
Siphoning Unit/Hose
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• HandleFasteningHardwareKit (which includes):
• Handle Bolts (2)
• Carriage Bolt (1)
• Rope Guide (1)
• Plastic Knobs for Handle (2)
• Plastic Knob (2)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and accessory tray.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
.
NOTICE
hot.
3.
.
insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit. Tighten by hand. By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store fiat atop the cold engine.
DONOT fold the handle down while the engine is
Placeaccessory tray (F) over holes (6) on handle
(viewing from back of unit). Push the tree clips (H) into
the holes until they sit fiat against the accessory tray.
/
insert supplied accessories in spaces provided in
accessorytray. See How to Use Accessory Tray.