Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONTROLS
Fuses
Fuses are located on the right hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7.5 A is for the mower deck coupling. The 10 A is
for accessories.
Cutting Height Controls
The cutting height pedal lifts the deck to allow
setting the desired deck height. For transport,
push the lift pedal fully forward until the deck lift
latches in the transport (highest) position.
To set the deck cutting height, release deck height
control by pushing forward on the pedal. Rotate
the cutting height pin 180
the pin into the hole for the desired cutting height.
The cutting height can be set from 1-1/2"- 5-1/2".
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.
to remove it and slip
O
Fuel Shut Off Valve
The fuel shut off valve is located at the right rear
of the seat. The valve has three positions: right
tank, left tank and OFF.
Tracking
If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
1. Tracking adjustments are made using the
tracking bolt and tracking knob. The tracking
bolt and tracking knob act as limiting devices
for the motion control levers when in the full-
forward position.
2. For preliminary tracking adjustment, move
unit to an open, unobstructed area such as an
empty parking lot or open field.
3. Back the tracking bolt out until flush with nut.
4. Loosen tracking knob out until flush with nut.
5. Test operate unit by driving it at full throttle and
the full forward position on both motion control
levers. Gradually turn in the tracking bolt on
the right hand side until the unit noticeably
starts drifting right.
6. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the tracking knob (left side)
until unit tracks straight.
15
Tabla de contenido
Solución de problemas
