Replace The Spool - GreenWorks POWERALL 48V Manual Del Operador

3. Insert the line into the mounting hole, which is located
inside the eyelet (23). Push the cutting line until it exits
the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Rotate the spool cover clock-wise in the arrow direction
to wind the cutting line into the trimmer head. Keep
approximately 5 in of cutting line above out of each side
of the trimmer head.
English
24
23
10.5
If any parts of the spool retainer assembly are damaged or
worn, replace the damaged part and reassemble them as
following showing
1. Disassemble the trimmer head . Pull and remove the
spool cover (b).
23
c
2. Clean dirt and debris from all parts. Replace spool (d) if it
is worn or damaged.
3. Loosen the screws (e). Remove the spool (d), slot covert
(f), location housing (g) from the spool assembly.
4. Replace with a new spool.
5. Insert the location housing and slot covert onto the spool
cover (b), and then put the spool onto the slot covert to
the disired position.
6. Tigthen with the screws.
e
11
5.1"
(130 )
mm
=

REPLACE THE SPOOL

NOTE
b
a
d
f
b
EN
5.1"
(130 )
mm
=
d
g