Refrigerator Doors; Tools Needed - Kenmore 106.3254 Serie Manual De Uso Y Cuidado

5. Turn shutoff valve ON. Check for leaks. Tighten any
connections (including connections at the valve) or nuts that
leak.
6. The ice maker is equipped with a built-in water strainer. If your
water conditions require a second water strainer, install it in the
¹⁄₄ " (6.35 mm) water line at either tube connection. Obtain a
water strainer from your nearest appliance dealer.
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced. Allow 3 days to completely fill
ice container.

Refrigerator Doors

TOOLS NEEDED: ⁵⁄₁₆ " hex-head socket wrench, #2 Phillips
screwdriver, flat-blade screwdriver, ⁵⁄₁₆ " open-end wrench, flat
2" putty knife.
IMPORTANT:
Before you begin, turn the refrigerator control OFF. Unplug
refrigerator or disconnect power.
Remove food and adjustable door or utility bins from doors.
If you are only removing and replacing the doors, see the
"Remove Doors and Hinges" and "Replace Doors and Hinges"
sections.
Depending on your model, you may have standard (Style 1) or
contoured (Style 2) doors. If you are also going to reverse the
door swing, follow the instructions for the appropriate door
style.
All graphics referenced in the following instructions are
included later in this section after "Final Steps."
8
All manuals and user guides at all-guides.com
1. Unplug refrigerator or disconnect power.
2. Close the refrigerator door and keep both doors closed until
3. Remove the parts for the top hinge as shown in Top Hinge
4. Remove the parts for the center hinge as shown in the Center
5. Remove the parts for the bottom hinge as shown in the Bottom
IMPORTANT: If you want to reverse your doors so that they open in
the opposite direction, follow these steps. If you are not reversing
the doors, see "Replace Doors and Hinges."
Style 1 - Standard
Graphics follow these instructions.
Cabinet
1. Remove ⁵⁄₁₆ " hex-head hinge screws from handle side and
2. Remove cabinet hinge hole plugs from cabinet top and
Remove Doors and Hinges
⁵⁄₁₆
" Hex-Head Hinge Screw
you are ready to lift them free from the cabinet.
NOTE: Provide additional support for the doors while the
hinges are being moved. Do not depend on the door magnets
to hold the doors in place while you are working.
graphic. Lift the freezer door free from the cabinet.
Hinge graphic. Lift the refrigerator door free from the cabinet.
Hinge graphic.
Reverse Doors (optional)
Door Stop Screw
Door Handle Sealing Screw
Flat-Head Handle Screw
Door Handle Seal Screw Front
move them to opposite side. See Graphic 1-1.
move them to opposite side hinge holes as shown.
See Graphic 1-2.
Door Hinge Hole Plug
Cabinet Hinge Hole Plug
Door Handle Screw Cover
Round-Head Handle Screw