Shutting Down And Clean Up; Storage; After Extended Storage; Engine Maintenance - Landa VHP2-1500 Manual Del Operador

Tabla de contenido
sTep 1: Remove detergent suction
tube from container and insert into
one (1) gallon of fresh water. Flush
detergent lines with fresh water,
switch to the pump position and
continue to spray water allowing
burner to cool.
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32°F (0°C). The pump in this machine is susceptible
to permanent damage if frozen. FREEZE DAMAGE
IS NOT COVERED BY WARRANTY.
1. Stop the pressure washer, squeeze spray gun trig-
ger to release pressure.
2. Detach water supply hose and high pressure hose.
3. Turn on the machine for a few seconds, until re-
maining water exits. Turn engine off immediately.
4. Drain the gas and oil from the engine.
5. Do not allow high pressure hose to become kinked.
6. Store the machine and accessories in a room which
does not reach freezing temperatures.
CAUTION: Failure to follow the above directions will
result in damage to your pressure washer.
When the pressure washer is not being operated or is
being stored for more than one month, follow these
instructions:
1. Replenish engine oil to upper level.
2. Drain gasoline from fuel tank, fuel line, fuel valve
and carburetor.
3. Pour about one teaspoon of engine oil through
the spark plug hole, pull the starter grip several
times and replace the plug. Then pull the starter
All manuals and user guides at all-guides.com
shuTTIng DoWn anD Clean-up
sTep 2: After water has cooled,
turn pump off. Turn main gas valve
off, then close the valve on the LP
tank. Secure the LP tank to the
machine when moving it.
sTep 4: Squeeze trigger on spray
gun to relieve remaining pressure.
Move safety latch into its locked
position.

sTorage

LANDA VHP • 8.913-949.0 • Rev. 5/13
pump switch
89139490-7
sTep 3: Turn the water off. To pro-
tect from freezing, pull the trigger
on spray gun to allow water to drain
from the system.
grip slowly until you feel increased pressure which
indicates the piston is on its compression stroke and
leave it in that position. This closes both the intake
and exhaust valves to prevent rusting of cylinder.
4. Cover the pressure washer and store in a clean, dry
place that is well ventilated away from open flame
or sparks. noTe: The use of a fuel additive, such
as STA-BIL
, or an equivalent, will minimize the
®
formulation of fuel deposits during shortage. Such
additives may be added to the gasoline in the fuel
tank of the engine, or to the gasoline in a storage
container.

after extended storage

CAUTION: Prior to restarting, thaw out any
possible ice from pressure washer hoses,
spray gun or wand.

engine maintenance

During the winter months, rare atmospheric conditions
may develop which will cause an icing condition in the
carburetor. If this develops, the engine may run rough,
lose power and may stall. This temporary condition can
be overcome by deflecting some of the hot air from the
engine over the carburetor area. noTe: Refer to the
engine manufacturer's manual for service and mainte-
nance of the engine.
13
Tabla de contenido
loading

Este manual también es adecuado para:

Vhp3-20001.109-556.01.109-557.0

Tabla de contenido