Tabla de contenido
DeTergenTs & general CleanIng TeChnIques
WARNING: Some detergents
WARNING
may be harmful if inhaled or
ingested, causing severe nau-
sea, fainting or poisoning. The
harmful elements may cause
property damage or severe
injury.
sTep 1: Use detergent designed
specifically for pressure washers.
Household detergents could dam-
age the pump. Prepare detergent
solution as required by the manu-
facturer. Fill a container with pres-
sure washer detergent. Place the
filter end of detergent suction tube
into the detergent container.
sTep 2: Apply safety latch to spray gun trigger.
Secure black detergent nozzle into quick coupler.
noTe: Detergent cannot be applied using the yellow
nozzle.
wise. This lowers the pressure by directing the water
flow through the soap nozzle and allow detergent
injector to siphon soap.
Apply detergent to work area. Do not allow detergent
to dry on surface.
IMPORTANT: You must flush the detergent injection
system after each use by placing the suction tube
into a bucket of clean water, then run the pressure
washer in low pressure for 1-2 minutes.
CleanIng TIps
Pre-rinse cleaning surface with fresh water. Place de-
tergent suction tube directly into cleaning solution and
apply to surface at low pressure (for best results, limit
your work area to sections approximately 6 feet square
and always apply detergent from bottom to top). Allow
detergent to remain on surface 1-3 minutes. Do not
allow detergent to dry on surface. If surface appears
to be drying, simply wet down surface with fresh water.
If needed, use brush to remove stubborn dirt. Rinse at
high pressure from top to bottom in an even sweeping
12
All manuals and user guides at all-guides.com
sTep 3: With the motor
running, pull trigger to oper-
ate machine. Liquid deter-
gent is drawn into the ma-
chine and mixed with water
at an approximate ratio of 15
to 1. Turn pressure control
handle on wand counterclock-
LANDA VHP • 8.913-949.0 • Rev. 5/13
motion keeping the spray nozzle approximately 1 foot
from cleaning surface. Use overlapping strokes as you
clean and rinse any surface. For best surface cleaning
action, spray at a slight angle.
recommendations:
• Before cleaning any surface, an inconspicuous
area should be cleaned to test spray pattern and
distance for maximum cleaning results.
• If painted surfaces are peeling or chipping,
use extreme caution as pressure washer may
remove the loose paint from the surface.
• Keep the spray nozzle a safe distance from the
surface you plan to clean. High pressure wash
a small area, then check the surface for dam-
age. If no damage is found, continue to pressure
washing.
CAUTION - Never use:
• Bleach, chlorine products and other corrosive
chemicals
• Liquids containing solvents (i.e., paint thinner,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the machine and will dam-
age the surface being cleaned.
rInsIng
It will take a few seconds for the detergent to clear.
Apply safety latch to spray gun. Remove black soap
nozzle from the quick coupler. Select and install the
desired high pressure nozzle. noTe: You can also stop
detergent from flowing by simply removing detergent
siphon tube from bottle.
Tabla de contenido
