Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PE SERIES PRESSURE WASHER
6
SHUT DOWN PROCEDURES
1. Rinse all lines (and injector) with clean water, to re-
move any soap residue.
2. Turn motor off.
3. Push red stop switch/toggle switch to OFF position.
4. Open spray gun to relieve remaining pressure.
5. Remove water supply hose.
6. In freezing conditions, disconnect water supply and
open spray gun to allow water to drain, then turn off
motor.
CAUTION: Do not allow pump to run longer than
5 minutes without water. Disconnect all hoses to al-
low water to drain.
CAUTION: With machine off, open spray gun to re-
lease pressure before removing discharge hose.
STORAGE
Pump Storage
CAUTION: Always store your pressure
washer in a location where the tem-
perature will not fall below 32° F
(0° C). The pump in this machine is
susceptible to permanent damage if
CAUTION
frozen.
FREEZE DAMAGE IS NOT COVERED
BY WARRANTY.
If you must store your pressure washer in a location
where the temperature is below 32° F, you can minimize
the chance of damage to your machine by draining your
machine as follows:
1. Stop the pressure washer and detach supply hose
and high pressure hose. Squeeze the trigger of the
spray gun to drain all water from the wand and hose.
2. Restart pressure washer and let it run briefly (about
5 seconds) until water no longer discharges from
the high pressure outlet.
LANDA PE • REV 10/02
OPERATOR'S MANUAL
Tabla de contenido
