Fitting The Operator Display Unit; Fitting Monitor - Bosch KMA 802 Manual Original

en 28 | KMA 802/822 | Initial Commissioning
4.1.2

Fitting the operator display unit

5
Fig. 7: Fitting the operator display unit
1. Secure four rubber buffers (fig. 7, item 5) to support
plate (fig. 7, item 3).
2. Place, position and secure support plate (fig. 7,
item 3) in long bores of EPS cover (fig. 7, item 4).
3. Remove retaining panel (fig. 7, item 1) from console
(fig. 7, item 2).
4. Set the console (fig. 7, item 2) onto the support
plate's (fig. 7, item 3) threaded studs and fasten in
place using a washer and a hex nut.
i
The scope of supply includes two coarse burr fas-
teners and two fine-grade burr fasteners. To secure
the keyboard, fit one coarse and one fine-grade burr
fastener to each side.
5. Secure keyboard (fig. 7, item 6) to console support
(fig. 7, item 2) with a burr fastener (fig. 7, item 7).
6. Unfold legs on left and right sides of keyboard.
|
1 689 979 674 2013-12-23
1
6
7
2
3
4
4.1.3

Fitting monitor

5
1
Fig. 8: Fitting and connecting the monitor
1. Pull the video cable and power cord through the
opening in the bottom of the mounting plate (fig. 8,
item 1).
!
Take care not to trap any cables when fitting the
mounting plate.
2. Position the mounting plate (fig. 8, item 1) on the
console (fig. 8, item 2) and secure.
3. Attach the mounting (fig. 8, item 3) to the monitor
(fig. 8, item 4) with bolts (M4 x 10) and a spring lock
washer (A4.2).
4. Fit monitor and holder to support plate (fig. 8, item 1).
5. Use the adjusting screw (fig. 8, item 5) to set the
angle of the monitor.
6. Swivel the monitor upwards and connect the video
cable and power cord.
7. Swivel the monitor downwards as far as it will go.
4
3
2
Robert Bosch GmbH