DeWalt DWS7085 Manual De Instrucciones página 5

3. Tuck the wire connection into
the area in the worklight as
shown. Attach the worklight to
the saw.
4. Attach the worklight with the
four screws removed in Step 1.
Tighten screws securely.
WARNING: Do not operate
the miter saw if any of the screws
are missing, stripped out or not
seated.
5. Manually open and close the guard to ensure no binding
occurs. With the guard closed, move the saw arm through a
full stroke to also ensure no guard binding occurs.
WARNING: To reduce the risk of serious personal
injury, Do not operate the saw if guard binding occurs.
Use of Miter Saw Worklight System
WARNING: Read all instructions for the Installation of Worklight
Power Supply and the Installation of Worklight before using the
Miter Saw Worklight System.
NOTE: The miter saw must be
connected to a power source.
The Miter Saw Worklight System is
equipped with an ON/OFF switch (C).
The Miter Saw Worklight System is
independent of the miter saw's trigger
switch.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
WARNING: To reduce the risk of serious personal injury,
DO NOT touch the sharp points on the blade with fingers or
hands while performing any maintenance.
For the best worklight performance, perform the following
maintenance regularly.
• Carefully clean sawdust and debris from worklight lens with a
cotton swab.
• DO NOT use solvents of any kind, they may damage the
lens.
• Dust build-up can block the worklight and prevent it from
accurately indicating the line of cut.
• Follow miters saw's instruction manual to remove and install
blade.
• With blade removed from saw, clean pitch and build-up from
blade. Pitch and debris can interfere with the worklight and
prevent it from accurately indicating the line of cut.
Light Source
Worklight
Power Supply
C
Operating Temperature 32°F to 104°F (0°C to 40°C)
Storage Temperature
Environmental
3
SPECIFICATIONS
Power LED
3.3 V DC
Input: 120–240 V AC; 50/60 Hz
Output: 3.3 V DC, 0.9 A
0°F to 185°F (-40°C to 85°C)
Water Resistant