DeWalt DWS7085 Manual De Instrucciones página 4

1. Remove the two screws from the miter saw handle with
the T20 wrench provided. Save the screws to install the
Worklight Power Supply (WPS) in Step 4. Retain the handle
cover for future use if WPS is removed.
2. Attach the connections to the WPS.
3. Arrange the wire connection
such that the wide portion of the
connector is placed against the
bottom of the miter saw handle
and fit the WPS to the handle.
4. Attach the WPS with the two
screws removed in Step 1.
INSTALLATION OF THE WORKLIGHT
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
WARNING: To reduce the risk of serious personal injury,
DO NOT operate saw without the cover or worklight in
place.
WARNING: To reduce the risk of serious personal injury,
DO NOT touch the sharp points on the blade with fingers or
hands when guard is open.
1. Remove the four screws (A) with the the T20 wrench
provided. Save the screws to install the worklight in Step 4.
Retain the cover for future use if worklight is removed.
NOTE: Manually open the guard (B) if needed to access and
remove the lower two screws (A).
A
(upper
screw)
B
2. Attach the connection from
lead wire to the worklight.
2
B
A
(lower
screw)