Shut Down Instructions; Assembly Instructions - Jocel JAT007445 Manual De Instrucciones

WHEN HEATER IS ON:
Emitter screen will become bright red due to intense heat. The color is more visible at
night. Burner will display tongues of blue flame. These flames should not be yellow or
produce thick black smoke, indicating an obstruction of airflow through the burners.
OPERATION PRESSURE CHECKED:
If the flame is very small, this is because the supply pressure is not enough. Please
refill gas cylinder.
RE-LIGHT:
1. Turn the control knob to OFF position.
2. Wait five (5) minutes before attempting to relight burner.
3. Repeat steps beginning with step 2 of the lighting instruction above.

SHUT DOWN INSTRUCTIONS:

1. Push in and turn control knob clockwise to OFF position.
2. Turn LPG cylinder gas valve clockwise to OFF position when heater is not in use.
NOTE: After use, some discoloration of the emitter screen is normal.
THE EVENT OF GAS LEAKAGE:
1. Turn the control knob to OFF position.
2. Turn LPG cylinder valve to OFF position.
3. Wait 5 minutes to allow gas to dissipate.
4. If odor continues, immediately call gas supplier.
Warning:
Heater will be hot after use.
Handle with extreme care.

ASSEMBLY INSTRUCTIONS

Number of people required to assemble: Two persons
Time to assemble: 60 min.
1. Find a large, clean area to assemble your appliance. Please refer to the parts list
and assembly diagram as necessary.
2. Please use protective gloves when assembling this product.
3. To avoid losing any small component or hardware, assemble your product on a
hard level surface that does not have cracks or openings.
4. To avoid damage to soft floor or carpet, do not assemble or move the appliance
on soft floor or carpet.
5. Follow all steps in order to properly assemble your product.
6. Make sure all the plastic protection rips off before assembling.
OFF
IGNITE
50
HIGH
LOW