Connecting Instructions; Operating Instructions - Jocel JAT007445 Manual De Instrucciones

CONNECTING INSTRUCTIONS

1. Turn the control knob OFF. Slowly open the gas
cylinder valve.
2. Push in and turn control knob anti-clockwise to IGNITE.
3. Keep control knob depressed for up to 30 seconds until
pilot is lit.
4. If pilot does not light, turn control knob to OFF and wait
2 minutes between ignition attempts for gas to
dissipate.
5. Failure to do this may result in flame roll out beyond the
emitter grid.
Note: it is possible to light the appliance using a long match, by lighting the burner through
the hole of guard mesh.
6. When the pilot is lit keep knob pressed for up to 20 seconds to heat the thermocouple
flame sensor, then release it (first ignition generally takes more time, because the gas
circuit is full of air).
7. If the pilot does not stay lit, repeat steps 2 - 4.
8. Turn knob to LOW position.
9. Adjust the heat input by turning the knob from the LOW position, to the HIGH position,
as required.
10. After lighting, turn knob from LOW to HIGH, position and back, to check flame stability.
11. In case of accidental break down of the flame (due to wind or other reasons), a Flame
Safely Device (FSD) will automatically shut-off gas supply within 90 seconds.
WARNING
These lighting instructions must be followed. An unsafe condition can occur
if they are not followed correctly.
FLAME CHARACTERISTICS
The flame pattern at the emitter screen should be visually checked whenever heater
is operated. Normally the burner flame is blue, but little yellow flame is acceptable.
If flames extend beyond surface of the emitter grid, or the phenomena of flame lift or
light back, or black soot is accumulating on the emitter grid or reflector, the heater
should be turned off immediately. The heater should not be operated again until the
unit is serviced and or repaired.

OPERATING INSTRUCTIONS

NOTE: The burner may be noisy when initially turned on, to eliminate excessive noise
from the burner, turn the control knob to the LOW position. Then, turn the knob to the
level of heat desired.
OFF
49
IGNITE
HIGH
LOW