Reer WEGA Manual Del Usuario página 19

Synchronizing the appliances for using additional cameras
01. Synchronizing the parent unit
- Activate the screen.
- Press the channel selector for (02) 5 seconds until the menu appears on the screen.
- Use the volume controls (03) + and – in order to choose the channel to be synchronized.
- Then press the brightness control (04) + in order to confirm the channel.
- The display shows DEL and PAIR.
- Use the volume controls (03) + and – in order to choose PAIR.
- Press the brightness control (04) + in order to confirm.
- The display shows "WAIT".
02. Synchronizing the camera
-- While the display shows "WAIT" switch on
the camera to be synchronized and place it to a
distance of not more than one meter.
- Press the recessed button (09) with a pen.
- The status LED (01) starts blinking.
- The display shows "PAIRED".
03. Terminating the synchronization
Switch off both appliances and switch them on again. Thereby, the synchronization is terminated.
Perform these steps 2, 3 and 4 consecutively for eventual further cameras.
Deleting one camera (if not anymore in use)
- Activate the screen.
- Press the channel selector for (02) 5 seconds until the menu appears on the screen.
- Use the volume controls (03) + and – in order to choose the channel to be synchronized.
- Then press the brightness control (04) +.
- The display shows "DEL" and "PAIR".
- Use the volume controls (03) + and – in order to choose "DEL".
- Press the brightness control (04) + in order to confirm.
- The display shows "DONE"
Switch off both appliances and switch them on again in order to terminate the
operation.
page 18
All manuals and user guides at all-guides.com
NOTE:
The baby phones have been
already synchronized during the
manufacturing.
Normally, it is not necessary to
synchronize the baby phone
again before use.
Perform the operation of
synchronization between camera
and screen only if absolutely
necessary.
ATTENTION:
No defects of the appliances
are present if there are inter-
ferences due to other devices.