Problem Solution - Worx Professional WU362 Manual Del Usuario

off center as the hole is started. Hold the tool firmly and place the tip
of the bit at the point to be drilled. Depress the switch trigger to start
the tool. Move the drill bit into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force or apply side pressure
to elongate a hole.
Tungsten carbide drill bits should always be used for
concrete and masonry. When drilling in metal, only use HSS
drill bits in good condition. Always use a magnetic bit holder
(not included) when using short screwdriver bits. When screw-
driving, apply a small quantity of liquid soap or similar to the
screw threads to ease insertion.
All manuals and user guides at all-guides.com
1
2
3
10

Problem solution

WHY DOES THE HAMMER DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the trigger, is
positioned in the lock function. Unlock the forward/reverse rotation
control by putting it into the required rotation position. Push the
trigger and the hammer drill will start to rotate.
THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY
TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you can find the
torque-adjusting ring between the chuck and the drill body. Position
1 is the lowest torque (screw driving force) and position 20 is the
highest torque (screw driving force). Position 21 is for drill operation.
Regulate the torque adjusting ring to a higher position to reach the
best result.
REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES
Charging time problems, having not used a battery pack for a
prolonged time will reduce the battery pack working time. This can be
corrected after several charge and discharge operations by charging
& working with your drill. Heavy working conditions such as large
screws into hard wood will use up the battery pack energy faster than
lighter working conditions. Do not re-charge your battery pack below
0 C and above 45 C as this will affect performance.
o o