Worx Professional WU362 Manual Del Usuario página 10

Operation instructions
Note: Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for driving in and loosening screws as well
as for drilling in wood, metal, ceramic and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion battery installed
in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to cool
down before recharging.
When the battery is charged for the first time and after prolonged
storage, the battery will only accept approximately 60% charge.
However, after several charge and discharge cycles the battery will
accept a 100% charge.
B) TO REMOVE OR INSTALL BATTERY PACK (See Fig.A)
Press the battery pack latch and remove the battery pack from the
drill. After recharge slide the battery pack into drill's battery port. A
simple push and slight pressure will be sufficient.
All manuals and user guides at all-guides.com
1
2
3
4
8
Operation
AUXILIARY HANDLE (See Fig.B)
Slide the handle onto the drill and rotate it to the desired working
position. To clamp the auxiliary handle, rotates the handgrip
clockwise. To loosen it, rotate the handgrip anti-clockwise. Always
use the handle during operation.
ON/OFF SWITCH (See Fig.C)
Depress the On/Off switch to start and release it to stop your drill.
The on/off switch is fitted with a brake function which stops your
chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and
torque with increased trigger pressure. Speed is controlled by the
amount of switch trigger depression.
Warning: Do not operate for long periods at low speed
because excess heat will be produced internally.
SWITCH LOCK (See Fig.C)
The switch trigger can be locked in the OFF position. This helps to
reduce the possibility of accidental starting when not in use. To lock
the switch trigger, place the rotation control in the center position.
REVERSIBLE (See Fig.C)
For drilling and screw driving use forward rotation marked "
(lever is moved to the left). Only use reverse rotation marked "
(lever is moved to the right) to remove screws or release a jammed
drill bit.
Warning: Never change the direction of rotation when the
chuck is rotating, wait until it has stopped !
"
"