Types Of Work - Hilti TE 1500-AVR Manual Del Usuario

All manuals and user guides at all-guides.com
5.1.2 Fitting the accessory tool
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go, turning it and
applying light pressure until it engages with an audible click.
◁ The product is ready for use.
Note
Use only the recommended grease supplied by Hilti. Use of unsuit-
able grease may cause damage to the product.
5.1.3 Removing the accessory tool
WARNING
Risk of injury! The accessory tool gets hot during use and may also
have sharp edges.
▶ Wear protective gloves when changing the tool.
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable
materials.
1. Pull the chuck back.
2. Remove the accessory tool.

5.2 Types of work

Warning! Risk of damage!
▶ Operation of the direction of rotation and/or function selector switch
while the tool is running may result in damage to the tool.
▶ Do not operate this switch while the tool is running.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Chiseling 4
Note
The chisel can be adjusted to 6 different positions (in 60° increments).
This ensures that flat chisels and shaped chisels can always be set to
the optimum working position.
If inadequate pressure is applied, the chisel will jump around uncontrol-
lably. Application of excessive pressure will result in a loss of chiseling
performance.
8 English
Printed: 02.02.2017 | Doc-Nr: PUB / 5070775 / 000 / 03
3
3