Electrical Connection - Cata G20 Manual Del Usuario

instructions provided in the "Adapting to different types of gas" section.
For maximum efficiency and minimum consumption, make sure that the gas supply
pressure complies with the values shown in the gas used is different from that
specified (or variable).a suitable pressure regulator must be installed on the supply
The union must be fitted on the end of the gas train. Complete with GJ1/2＂threaded
nut, fitting the gasket between the components as shown in the illustration. The
gaskets must comply with the local standards. Screw the parts together without
forcing, fit the union so that it points in the direction required then tighten all parts.
Make the connection to the gas system using a rigid metal pipe and regulation unions,
or with a stainless steel hose complying with the local standard. If metal hoses are
used, take care that they do not come into contact with mobile parts and are not
crushed. This must also be checked if the hob is to be combined with an oven.
The gas intake connection of the appliance has a " male thread."
When making the connection, take care not to apply stresses of any kind to the
When the installation is complete, always check that all the unions are
absolutely tight using a soapy solution. Never use a flame to make this
The appliance is profited to operate with a power
supply voltage of 230Vsingle-phase. The connection
must be made in accordance with the regulations and
Before making the connection, make sure that:
7) the safety circuit-breaker and the electrical
system are able to withstand the load of the
appliance(see nameplate).
8) The power supply system has an earth
connection in good working order in accordance
with the regulations in force;
9) The socket or omni polar switch use are easily
accessible with the appliance installed.
Connection
appliance.

Electrical connection

laws in force.
pipeline.
check.