Stanley FatMax FMFP70979 Manual De Instrucciones página 20

CODE POSSIBLE CAUSE
9 Compressor is not large enough for acces-
sory
10 Hole in air hose
11 Check valve restricted
12 Air leaks
13 Regulator is damaged
14 Unit operating in damp or humid conditions
15 Restricted air intake filter
16 Pump oil is low
17 Carbon build-up in pump.
Detergent type oil being used in pump
18
Motor overload protection switch has tripped See Motor Overload under Features.
19
20 Extension cord is wrong length or gauge
Loose electrical connections
21
Possible defective motor or starting
22
capacitor
All manuals and user guides at all-guides.com
POSSIBLE SOLUTION
Check the accessory air requirement. If it is higher than the SCFM or pres-
sure supplied by your air compressor, a larger compressor is needed to
operate accessory.
Replace air hose.
Remove, clean or replace.
Tighten fittings.
Replace.
Move unit to a dry well ventilated area
Clean or replace air intake filter
Add air compressor oil (SAE 40) to pump. See Compressor Pump Oil under
Maintenance.
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
Drain oil and refill pump with air compressor oil (SAE 40).
Check for proper gauge wire and cord length. See Extension Cords under
Installation.
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
Contact a Stanley Tools factory service center or a Stanley Tools authorized
service center.
20