Reducer Piece; Attaching / Detaching Sanding Sheets; Rotating The Backing Plate; Advice On Use - Parkside PHS 160 B2 Instrucciones De Utilización Y De Seguridad

Preparing for use / Maintenance and cleaning
Note: Empty the dust collector in good time in or-
der to ensure the optimum removal of
suction.
To do so, remove the dust box
vice as described above. open the dust box
by pulling on the tab
Now tap both parts to thoroughly clean them.

Reducer piece

Q
Connection:
P ush the reducer piece
port .
2
P ush the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the reducer piece
Removal:
P ull the dust extraction device hose off the
reducer piece .
3
P ull off the reducer piece
Attaching / detaching
Q
sanding sheets
Always pull the mains plug is out
of the socket before doing any work on the device.
Attaching:
S anding sheets are attached to the backing plate
by means of the hook and pile fastening.
7
Detaching:
S imply pull the sanding sheet off the backing
plate (see Fig. C).
7

Rotating the backing plate

Q
Always pull the mains plug is out
of the socket before doing any work on the device.
R otate the backing plate
position (see Fig. D).
26 GB/MT
dust by
4b
from the de-
4b
and remove the cover.
4a
into the adapter
3
.
3
.
3
into the desired
7
Sanding and surfaces:
The sanding output and the quality of the surface
finish are determined by the grade of grit on the
sanding sheet.
A lways use sanding sheets with grades that
are suitable for the particular surface you are
sanding.

Advice on use

Q
S witch the device on before placing it against
the workpiece.
A pply light sanding pressure only.
A dvance the device at an even rate.
C hange sanding sheets at the appropriate time.
D o not work on different types of material using
the same sanding sheet (e.g. wood and then
metal). To achieve the best sanding results you
should use unworn, undamaged sanding sheets.
C lean the sanding sheet from time to time with
a vacuum cleaner.
S and difficult to reach places with the front or
side corners of the backing plate
W ork in parallel and overlapping widths.
A fter sanding the workpiece, lift the device
from the workpiece before switching it off.

Maintenance and cleaning

Q
Always pull the mains plug is out
of the socket before doing any work on the device.
The delta sander is maintenance-free.
C lean the device frequently. This should be done
immediately after you have finished using it.
F or cleaning the housing use a dry cloth only.
R emove any adhering sanding dust with a
narrow paint brush.
N ever any kind of sharp object or petrol,
solvents or cleaning agents that might attack
plastic. Do not allow any liquids to enter the
inside of the device.
A lways keep the ventilation slots
.
7
clear.
6