Idiomas disponibles
Idiomas disponibles
The Installer Tool guide-pin D is guided into
threaded hole in crankshaft during the fitting
sequence. This ensures the timing ring
reaches its final installation position.
Screw large hex nut A up threaded spindle
until it lies against the tool housing. Then
tighten this large hex nut to 35 Nm, this will
press the timing ring onto the crankshaft. After
tightening the hex nut, there must be a small
air gap between the seal housing and the
cylinder block.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Secure tool and new seal housing assembly to
crankshaft flange with the Allen-headed bolts A.
To guide the seal housing, screw two M6 x 35 mm
bolts into cylinder block (X).
NOTE: Screw Allen-headed bolts A into crankshaft
flange (approximately 5 full turns).
Unscrew large hex nut A to end of threaded spindle,
then remove the two guide bolts B from cylinder block.
Unscrew the three knurled screws C out of housing.
Pull assembly tool D back to large hex nut A (only for
sealing housing with spring ring).
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
