12 electrolux
INSTALLATION
•
Remove any promotion label from the
door.
•
The oven should be installed on a fl at,
level surface. The surface must be
strong enough to safely bear the weight
(12.6 kg) of the oven, and the contents.
To avoid the possibility of causing
vibration or noise the oven must be in
a stable position.
•
Keep the oven away from heat and
water. Exposure to heat and water
can lower oven effi ciency and lead to
malfunctioning, so be sure to install the
oven away from heat and water sources.
•
Do not block air vents on the top and
the sides of the cabinet and also do not
place any articles on the top of the oven.
If air vents are blocked during operation,
the oven may overheat, and this may
lead to malfunctioning. Hot air escapes
from the vents, so be sure not to obstruct
it or let curtains come between the oven
and the rear wall.
•
Place the oven as far away from radios
and TV's as possible. This oven does
conform to EEC requirements of radio
interference suppression, but some
interference may occur if it is placed too
close to a radio or TV, so keep them as
far apart as possible.
•
If positioned in a corner, leave a gap of
at least 15 cm from the walls and 15 cm
above the microwave.
Important! The oven can be placed
almost anywhere in the kitchen. Make sure
the oven is placed on a fl at, level surface
and that vents as well as the surface
underneath the oven are not blocked
(for suffi cient ventilation).
Connecting to the mains
The oven is delivered with the power cord
and a plug for 230-240V / 50 Hz earthed
socket outlet. Earth protection minimises
the risks should a short circuit occur. Check
to ensure the voltage of the oven matches
the supply.
If the oven is connected to the socket
via an extension cord, make sure the
cord is earthed.
Warning! This appliance must not
be used on a non earth protected
power supply. Contact an electrician if
you are uncertain regarding electrical
connection of the oven or provision of
earth protection of the supply.
Warning! This appliance must be
earthed. If this appliance is fi tted
with a non re-wireable plug for which
your socket is unsuitable, it must
be replaced by the manufacturer, its
service agent or similarly qualifi ed
persons in order to avoid a hazard.
Warning! If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or
similarly qualifi ed persons in order to
avoid a hazard.