Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Certified by Approved Body: SATRA, Safety Product Centre,
SATRA House, Rockingham Road, Kettering, Northants,
NN16 9JH. Identification No:0321. Production Control is
audited by the BSI - Identification Number 0086.
SpanSet recommends that where possible all PPE be
personal issue.
A full body harness is the only acceptable body holding device
that can be used in a fall arrest system.
It is essential that this product is sold to the end user with the
instructions in the correct language of the country in which the
product is to be used.
This harness is for use in a fall arrest system that has had a
thorough risk-assessment including an analysis of the clearance
necessary below the user to ensure safety.
Always thoroughly inspect all equipment and components
before and after fitting, pay particular attention to the operation
of buckles and connectors.
If the harness is to be used for fall arrest, only use with a CE
approved fall arrest system.
To connect a system together, refer to the user instructions for
each individual part.
Ensure that all equipment and components used within the fall
arrest system are compatible.
Any karabiner, or connector used must comply with EN 362, and
be securely locked to prevent opening.
Only connect steel chest and dorsal attachment points
(indicated by a letter 'A' symbol) to fall arrest or work
positioning systems.
Any anchorage point used should meet the requirements of
EN795 (10kN). We recommend that all persons using fall-arrest
equipment should take care to follow best practice procedures
when selecting anchor points. This means selecting lanyard
anchor points at or above shoulder height, wherever possible,
and adjusting the harness correctly. This is to reduce both the
physical effects on the body of the user generated by the arrest
of the fall, and the distance fallen. Safe clearance above the
hazard must always be ensured - comply with user instructions
for every component. During use protect all equipment from
sharp, or rough edges, and any chemicals. Avoid contact with
SPANSET HARNESS
GBR
Fitting and Use Instructions
hot surfaces and exposure to hot gases such as those from
blowlamps or welding torches.
environment that will adversely affect your equipment,
regularly examine your equipment during use to ensure its
integrity.
FITTING INSTRUCTIONS
1. Locate the rear fall arrest link - indicated by letter 'A' label
on strap.
2.
Fit harness over both Shoulders.
3.
Attach chest strap. And adjust to suitable tension by pulling
on the free length of webbing. IMPORTANT. Do not
overtighten the chest strap. The straps A & B should be as
close to parallel as possible in order to minimise the risk
of injury in the event of a fall.
4.
Fit thigh straps - left strap to left buckle, right strap to right
buckle - DO NOT CROSS.
5.
Adjust to a suitable tension by pulling on free-length of
webbing, then slide web tidy back (as indicated in the
diagram A,B,C)
6.
When standing upright the harness should be comfortable,
without undue pressure on chest, shoulders, or pelvic area.
Connecting the buckle system.
B Tensioning the buckle system.
C Sliding the web tidy back.
ADDITIONAL WARNINGS
1. Persons using this product should be trained/competent in
its use, or be under the supervision of such a person.
2. Be aware of all medical conditions that could affect the
safety of the user in normal and emergency use.
3. A rescue plan should be in place to deal with any
emergencies that may arise during work at height.
4. No alterations, additions or repairs should be made to this
equipment without the written consent of SpanSet.
5. The equipment shall not be used outside its limitations, or
for any other purpose than that it is intended for.
If you do work in an
1
Tabla de contenido
