Using Borescope - BGS technic 63247 Instruction Manual

Install / exchange batteries
The batteries are located at the bottom of the handle
Loosen the screw on the battery compartment lid using a cross-head screwdriver.
Push the battery compartment lid away from the casing in the screw direction.
Remove the battery compartment.
Install 4 new batteries of type 1.5 V AA into the battery compartment (Remove the used batteries first).
Observe the correct battery polarity. This is displayed within the battery compartment.
Replace the battery compartment into the casing in the correct direction, and then replace the battery
compartment lid.
Mounting the gooseneck
Slide the guide pin of the gooseneck into the groove in the plug and fasten the gooseneck at the device.
Accessory assembling
1 Camera
2 Retaining sleeve
3 Accessory, e.g. Magnet
Using the Borescope
1. To switch the Borescope on, use the „On / Off" button. The Power LED will light up and shows that the
unit is functional. The LCD display displays the camera image. To switch the Borescope off, use the
On / Off button. The Power LED will be switched off and the LCD display will also be switched off.
2. Set the image brightness to the desired level by pressing the „LCD Brightness" button. The brightness
level 0 to 30 is shown in the display. Each time the "LCD Brightness" button is pressed, the brightness
is set one step higher and then jumped to the lowest brightness level 0 after the highest brightness
level 30 is reached, etc.
3. Set the desired brightness of the camera illumination by pressing the "LED Brightness" button. The
brightness of the LED camera illumination is adjustable in 6 steps.
4. The "Color / Black-White" button can be used to switch between color or black-white display.
5. Place the flexible gooseneck into the area to be examined. Make sure that the gooseneck is always
easy to manoeuvre. You can move the gooseneck in every conceivable direction, making it possible
to examine areas that would otherwise be difficult to access.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
4
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed